Moxa AWK-5222-EU Manuale Utente Scaricare il pdf (Pagina 16)

AWK-5222 User’s Manual Getting Started

2-4

Step 5: Select the operation mode for the AWK-5222.

By default, the AWK-5222’s operation mode is set to Wireless redundancy. You can change the

setting in Wireless Settings Æ Operation mode if you would like to use the Wireless bridge or

AP-Client mode instead. Detailed information about configuring the AWK-5222’s operation can

be found in Chapter 3.

Step 6: Test communications.

We will describe 2 test methods to make sure the network connection has been established. Please

refer to the following section for more details.

Communication Testing

After installation, you can run a sample test to make sure the AWK-5222 and wireless connection

are functioning normally. Two testing methods are explained in the following sections. Use the

first method if you are using only one AWK-5222 device, and use the second method if you are

using two or more AWK-5222s.

Testing Method for one AWK-5222

If you are only using one AWK-5222, you will need a second notebook computer equipped with a

WLAN card. Configure the WLAN card to connect to the AWK-5222 (NOTE: the default SSID is

MOXA_1), and change the IP address of the second notebook (B) so that it is on the same subnet

as the first notebook (A), which is connected to the AWK-5222.

After configuring the WLAN card, establish a wireless connection with the AWK-5222 and open a

DOS window on Notebook B. At the prompt, type

ping <IP address of notebook A>

and then press Enter (see the figure below). A “Reply from IP address …” response means the

communication was successful. A “Request timed out.” response means the communication failed.

In this case, recheck the configuration to make sure the connections are correct.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 99 100

Nessun commento

Moxa AWK-5222-EU Manuale Utente Pagina 16