Moxa AWK-3121-EU Guida di Installazione Scaricare il pdf (Pagina 4)

the first AWK-3121 connected to notebook A, and change the second or

third AWK-3121 connected to notebook B to Client mode and then

configure the notebooks and AWK-3121s properly.

After setting up the testing environment, open a DOS window on

notebook B. At the prompt, type

ping IP address of notebook A

and then press Enter key. A “Reply from IP address …” response means

the communication was successful. A “Request timed out.” response

means the communication failed. In this case, recheck the configuration

to make sure the connections are correct.

Panel Layout of the AWK-3121

Top Panel View

Front Panel View

Rear Panel View

1. Grounding screw

erminal block for PWR1, PWR2,

relay, DI1, and DI2

3. Reset button

4. Heat dissipation orifices

5. System LEDs: PWR1, PWR2,

PoE, FAULT, and STATE LEDs

6. LEDs for signal strength

7. WLAN LEDs: CLIENT BRIDGE,

and WLAN LEDs

8. RS-232 console port

9. 10/100BaseT(X) RJ45 Port

10. 10M LED

11. 100M LED

12. MAIN antenna port

13. AUX antenna port

14. Model name

15. Screw hole for wall mounting kit

16. DIN-Rail mounting kit

- 4 -

1 2 3 4 5 6 7 8 9 ... 13 14

Nessun commento

Moxa AWK-3121-EU Guida di Installazione Pagina 4