Moxa IMC-101G Guida di Installazione Scaricare il pdf (Pagina 6)

- 6 -

STEP 2:

Mounting the IMC-101G on the wall requires 4

screws. Use the IMC-101G, with wall mount plates

attached, as a guide to mark the correct locations of the

4 screws. The heads of the screws should be less than

6.0 mm in diameter, and the shafts should be less than

3.5 mm in diameter, as shown in the figure at the right.

6.0 mm

3.5 mm

NOTE

Test the screw head and shank size by inserting the screw into one of the

keyhole shaped apertures of the Wall Mounting Plates, before it is screwed into

the wall.

Do not screw the screws in all the way—leave a space of about 2 mm to allow

room for sliding the wall mount panel between the wall and the screws.

STEP 3:

Once the screws are fixed in the wall, insert the four screw heads through the

large parts of the keyhole-shaped apertures, and then slide the IMC-101G

downwards, as indicated below. Tighten the four screws for added stability.

IMC-101G

1000M

IMC-101G

1000M

II 3G

ATEX Information

1. Certification number DEMKO 09 ATEX0812123x

2. Ambient range (-40°C ≤ Tamb ≤ 75°C)

3. Certification string (Ex nC nL IIC T4)

4. Standards covered ( EN60079-0:2006, EN60079-15:2005)

5. The conditions of safe usage:

y The Ethernet Communication Devices are to be mounted in an IP54

enclosure and used in an area of not more than pollution degree 2 as

defined by IEC60664-1. A 4mm2 conductor must be used when

connection to the external grounding screw is utilized. Conductors

suitable for use in an ambient temperature of 93°C must be used for the

Power Supply Terminal.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Nessun commento

Moxa IMC-101G Guida di Installazione Pagina 6